zap channel did question

2 posts / 0 new
Last post
krtorio
krtorio's picture
zap channel did question

I have a question regarding the zap channel DIDs feature in freepbx.

It seems this is used for analog pstn lines, but I was wondering if this is applicable also to PRI T1/E1 DIDs.

I'm asking because I found a link that shows how to route PRI DID calls, but using plain asterisk:

http://www.techrepublic.com/article/solutionbase-configure-asterisk-to-support-a-t1-pri-connection/94140

In the article I don't see anywhere the step where you need to assign zap channel to a DID number.

SkykingOH
SkykingOH's picture
This article does not apply

This article does not apply to FrePBX.

Zap DID's are for FXO lines so you can route on a per port basis.

Any circuit capable of sending DNIS information (like a PRI) uses the standard inbound routing module.