FOP Panel not available after install
I originally tried the install with *Now and for whatever reason the reporting/recording would never work on the base install and I could not figure out how to make it work. I then decided to try it from scratch. Used a base install of CentOS 5 and for the most part followed this install guide:
http://www.powerpbx.org/content/centos-asterisk-freepbx-install-guide-ce...
Upon completion everything appears to work except the FOP Panel. When I try to go directly to it or to it from the display it simply gives me the page not found. Was there something I needed to add to include this when I built FreePBX?
When running amportal stop_fop and amportal start_fop everything appears to start properly.
__________________
News Announcements
New Forum Topics
- no inbound calls showing up in monitor section
- Yum won't update
- Need ability to have weather announcment on a special voicemail.
- Disabling Enum
- End-Point-Manager over Internet
- Freepbx 2.10 Recordings portal not working
- Error with style after upgrade
- Soft phone for iphone
- hi ,can anyone help me please ,i want to add custom port 7060 after my domin
- only group 0 shows up in trunk drop down list.
- Day/Night BLF
- Errors with "ARI" After update, Asterisk Failure and Interface won't load
Save yourself a lot of grief
Save yourself a lot of grief from installing from scratch and install a precompiled distribution like PBX in a Flash or Orgasmatron. You will also have better support as the configuration will be standardized and the support forums will know exactly how your configuration should be.
Eugene Blanchard
Author of PBX in a Flash for Newbies and Introduction to Data Communications