I have setup a new system using the 126.96.36.199 freepbx distro. All is going quite well so far in as much as using SIP trunks. I can call into the line and route calls etc and outbound is all working well enough. However now I need to test the system with our ISDN 30 line.
I have created an incoming route for our main switchboard number, installed and configured an ISDN TD120 card, created a Dahdi trunk, which successfully selects g0 as the DAHDI identifier. I have not set up any Dialed Manipulation rules as for now I just need to make and accept any call. If I try and call in the call just fails and if I try an dial out I get a system message "all circuits are busy now"
I really need to get this tested and working so any pointers would be greatly appreciated