How to create inbound and outbound trunks
Recently installed freepbx. As I am newbie, I searched this forum for configuring Freepbx as a gateway for inbound and outbound sip calls.
I found that to connect to external gw, I can make configuration like:
add a Trunk; Trunk Name: ABC
And put the information in Peer Details ONLY, and DO NOT add anything in Incoming Settings;
allow=all
host= xxx.xxx.xxx.xxx # IP address of your gw
type=peer
And than add the Outbound Routes for;
9XXXXXXX
9XXXXXXXX
9XXXXXXXXXX
9XXXXXXXXXXXXX
For the incoming calls, I am confused. Should I create trunk with only details in incoming setting like:
host= xxx.xxx.xxx.xxx
context=outbound-all-routes
secret= password
type= peer
Should I have to add anything in outgoing settings?
__________________
News Announcements
New Forum Topics
- I've been hacked!!!
- no inbound calls showing up in monitor section
- Yum won't update
- Need ability to have weather announcment on a special voicemail.
- Disabling Enum
- End-Point-Manager over Internet
- Freepbx 2.10 Recordings portal not working
- Error with style after upgrade
- Soft phone for iphone
- hi ,can anyone help me please ,i want to add custom port 7060 after my domin
- only group 0 shows up in trunk drop down list.
- Day/Night BLF
sip trunk settings
Look here - http://www.voipvoip.com/trixbox/ - may not apply to you but the config should work okay. Whos the provider ? Have they not sent you the config ?
freepbx as a gateway to route calls
Thank you for the reply. I checked the site.That gives configuration for 1 provider only. I want to make freepbx to route calls coming from 1 provider to the terminating end like quintum tenor AX.
I found way to make trunk for outbound calls with the above setting. But I am confused, when a provider want to send me calls through a ip xxx.xxx.xxx.xxx, which I want to route to terminating end through Freepbx, which could monitor all the calls.
I found one setup for tribox to tribox connecting through IAX2 trunk. This guide tells to create 2 trunks in 2 triboxes with outgoing and incoming settings for each other. But for me, I want to have 1 trunk for incoming calls, and another for outgoing only. I couldn't create trunk with only incoming settings. Should I need to have outbound settings also configured in it?.
Please give some suggestions.