cgrozev's picture
Posted September 28th, 2008 by cgrozev (tadpole)

Hi. I have been attempting to do an attended transfer, using an SDK package from Ageet which uses the Refer-To with replaces header...Bottom line is, I put both A and B on hold, but when I attempt to transfer A to B, A receives an incoming call (with B's caller-id). If I accept that call at A, it all works fine - A and B are connected and the transferror is out of the loop....but I do not want the ring-back...I just want to connect A to B during the initial call session.

Anyone have an ida what I may be doing wrong?

Best regards

Christo


__________________


‹ calls not put through to agents in queue ! Fax to Email help and suggestion ›

Comment viewing options

Select your preferred way to display the comments and click "Save settings" to activate your changes.

Why not just use *2. It is

jmullinix's picture
On September 28th, 2008 jmullinix (Leap Frog) said:

Why not just use *2. It is built into FreePBX.


__________________

John Mullinix, Cohutta.Com, Inc.
1-706-632-3343 -- sip://17066323343@qth.cohutta.org
Looking for Dundi peers in Baltimore, MD and Lake Wales, FL USA


I just did. new (smaller problem)

cgrozev's picture
On September 28th, 2008 cgrozev (tadpole) said:

Thanks a lot John -
i just discovered that myself, after 1 whole week of trying to accomplish this via the SDK.

The *2 works great, except for the following: there is a 15 second no-answer timeout during the attended transfer, and I can't seem to find the conf file that would change this timeout. Obviously, 15 sec is way too.

Any idea?

thanks again
Christo