fdecher's picture
Posted November 12th, 2008 by fdecher (tadpole)

Hi,

here´s the setup:

I get a call from pstn.
When a call comes in I add a zero as prefix (this is needed for call back.).
This is done in extensions_custom.conf

everything works fine.

but sometimes I need to forward a call through a SIP trunk into another SIP PBX.

I thoght I could create a trunk-custom thing in the extensions_custom.conf where I remove the prefixed zero from the Caller ID Number when a call is established through this sip trunk.

But I don´t get it to work.

(the other SIP system don´t need the 0 as prefix).
The other PBX system is "dumb" so I have no chance to remove it there.


__________________


‹ How to use common SIP/PSTN lines via dundi between 2 asterisks.. Configuring Webmin - ›

Comment viewing options

Select your preferred way to display the comments and click "Save settings" to activate your changes.

The route to the dumb pbx

fskrotzki's picture
On November 12th, 2008 fskrotzki (Contributor) said:

The route to the dumb pbx system uses a trunk you defined on your system right? Take a look at the dialing rules for the trunk you can create a removal dial pattern (to see the format cursor over the words "Dial Rules:").


Thank you very much for the

fdecher's picture
On November 12th, 2008 fdecher (tadpole) said:

Thank you very much for the quick answer,

but with the dialing rules and pattern i only can modify the dialed number and not the original callers ID number.
Or did I missed something.


no you are right I missed

fskrotzki's picture
On November 13th, 2008 fskrotzki (Contributor) said:

no you are right I missed it. I flipped the problem in my head.


*push*

fdecher's picture
On November 28th, 2008 fdecher (tadpole) said:

any tipps?

thank you.